Name:

Contact:

Company:

Email:

Comments:


The product tests di-electric withstand capacity of various insulating paths in a switch such as L-N poles shorted with respect to the earth pin, adjacent poles, terminals to body

PLC based Socket Di-Electric Routine Test Bench(IEC 60669 BS EN 60669 IS 3854)

Routine Test

The SCR Elektroniks Socket Di-Electric Test Bench is designed to verify the high voltage testing of household sockets as per IEC 60669, IS 1293 and BS EN 60884. The system employs Siemens PLC to carry out the test sequence and test parameter (timing) setting. The di-electric strength test is referred to as Clause 16.2 in the following standards:IEC 608849 BS-EN 60884 IS 1293.The above test can be customized with respect to the test voltage (kV), leakage current measurement (mA), test time, etc.

In addition, there is a continuity test module which helps in checking the conformance of the socket to ensure complete reliability of the switch w r t operation and safety before being shipped out for sale.

Stand-alone unit after initial configuration of test parameters: The operator just pushes a push button for initiation of the test sequence

User friendly Front control panel for easy setting of parameters

Siemens PLC for completely automated operation

Specially designed fixture for safe operation with operator safety in view

User selectable threshold mA leakage current

Diagnostic mode for periodical debugging and diagnostic check of machine / controls and fixture

Mounted on castor wheel

Input voltage: 230 V

50 / 60 Hz operation as per incoming line frequency

Test voltage: 200 V – 1500 V

Threshold Leakage current setting: 2, 5, 10, 20, 50 mA

Pneumatic Pressure: approximately 6 bar

Class 1 Accuracy for measurement of current and voltage

The product can be made PC based or PLC based. The maximum di-electric withstand level (kV) can be customized. A 2-in-1 switch / socket dielectric withstand test can also be designed and integrated in a single bench with two distinct set of fixtures, one for switch testing and other for socket testing

The product tests di-electric withstand capacity of various insulating paths in a switch such as L-N poles shorted with respect to the earth pin, adjacent poles, terminals to body, etc. as given in IEC standard. The yield of this equipment is extremely high, thus enabling rapid testing of sockets

Products from same category

The SCR Elektroniks 3 station Switch Endurance Test Bench is designed to verify the endurance testing of household and rocker switches
Endurance Test Setup for Switches
This stand alone unit is used to verify the endurance testing of sockets
Endurance Test Bench for Socket
The Switch Di-Electric Test Bench is designed to verify the high voltage testing of household and rocker switches
PLC based Switch Di-Electric Routine Test Bench
The product tests switch and socket together for the dielectric withstand test
High Voltage Test Setup for Switches & Sockets