This is designed for Testing of MCB to carry out “Test of Instantaneous Tripping

MCB Magnetic (Instantaneous) Trip Test Bench (IEC 60898 Clause 9.10 and test d and e in Table 7 of IEC 60898 clause 8.6.1. IS 8828)

Routine Test R&D

The test bench is specially built for low voltage- B, C & D curve MCBs. Specially designed custom built jigs are able to accommodate single, double, three and four pole MCBs. Decades of experience has helped us to design current source (transformer) in a special way such that good current regulation and high accuracy is ensured with a variable range without the use of any variable transformer in the system. The product is better than the competition with conventional technology at a lesser price!

Products From Same Category

The MCB Thermal Trip Calibration Test Bench is a fully automatic stand alone equipment
4 Station Thermal & Calibration Test Bench
The 28 days Test Bench can work in single as well as three phase mode
3-Phase-28-Days Temp-Rise-Test
It is a programmable High Voltage Tester for MCB equipments
High-Voltager-Tester
The test bench tests mechanical and electrical endurance characteristics of MCB for quality assessment purposes
MCB Endurance Test Bench
The test is intended to check the instantaneous trip (magnetic trip mechanism) characteristics of an MCB as per its rating and curve at a conveniently low voltage
MCB-Instantaneous-Trip-Test-Bench
The test, similar to that of an MCB, is carried out to measure the power loss across each pole
MCB Temperature Rise and Power Loss Test Bench
The tester is used to carry out the 1.13 and 1.45 test, optionally inside a heated environment (temperature chamber)
MCB Tripping Current Characteristic Test Bench
The test bench is primarily designed to hold and connect multi pole MCBs for thermal verification
MCB-Thermal-Calibration-Verification-Test-Bench
This product is used by leading MCB manufacturers on their lab & production floor
PC-Based-Thermal-+-Magnetic-Test-Bench-for-MCB
Glow Wire Test Apparatus – GWT A2 (Automatic)
Glow Wire Test Apparatus – GWT A2 (Automatic)
The tester is used to simulate a particular impulse (1.2 / 50 microsecond) so as to assess the insulation characteristics of a breaker against a real world impulse experienced by the MCCB
Impulse Tester 10,700mfd
The product is used to measure the millivolt drop at a high dc voltage or to assess the micro-ohms of an MCB
millivolt drop tester